Jump to content
Carol Baldwin

error 401 and print size issue

Recommended Posts

Carol Baldwin

I am getting an "error 401" popup each time I engage NitroPro, yet I am still able to create and save pdfs.

However, when I go to print, the 8 1/2 X 11 image the pdf purports to be, prints in reduced size rather than full 8 1/2 X 11. 

I am running v. 13.2.2.25 and have run the repair modification with no luck. 

Share this post


Link to post
Share on other sites
Reymund G.

Hi @Carol Baldwin,

Thank you for reaching out to us through our Community Forums!

Please open your Nitro Pro installation then close the 401 error message if it shows up. At the top right, logout then login again using your Nitro Sign account. 
After these steps, please observe if you still get the same error message.

Regarding the printing, could you please share your printing workflow and a copy of the image so we can check if the issue can be reproduced on our end?

Kind regards,

Share this post


Link to post
Share on other sites
Carol Baldwin

Thanks for your help. Your directions worked. 

The  print issue was not related to the 401 error message and has been resolved

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.