Since the upgrade, I cannot print a blueprint to correct dimensions, i.e. 24" x 36". If the original document is 24x36 and I try to print in portrait mode, it prints 36x36 and cuts part of the print off(doesn't print all of it). If I do it in landscape mode, it will print the entire thing but again in 36x36 with a one foot x 3 foot blank section on one side. A tremendous waste of paper. I had no problem before the upgrade with printing even 36x48 and this is b.s. I haven't tried to print one that size. I've wasted a lot of paper and ink going through different settings trying to get one correct print. Can't do it.
Since the upgrade, I cannot print a blueprint to correct dimensions, i.e. 24" x 36". If the original document is 24x36 and I try to print in portrait mode, it prints 36x36 and cuts part of the print off(doesn't print all of it). If I do it in landscape mode, it will print the entire thing but again in 36x36 with a one foot x 3 foot blank section on one side. A tremendous waste of paper. I had no problem before the upgrade with printing even 36x48 and this is b.s. I haven't tried to print one that size. I've wasted a lot of paper and ink going through different settings trying to get one correct print. Can't do it.
Wade
Share this post
Link to post
Share on other sites