Jump to content

Command parameters not working


Recommended Posts

I am trying to deploy Nitro PDF through SCCM and I am trying out the command line installation on a test system, this is what I got from the NitroPDF documentation


msiexec /i nitro_pro11_x64.msi /qb NPSERIAL=1XXX

This is not a quiet install, as it pops up a dialogue box to click yes  so I have tried

msiexec /i nitro_pro11_x64.msi /qn NPSERIAL=1XXX and msiexec /i nitro_pro11_x64.msi /q NPSERIAL=1xxx

None of them is working, any input in this will be much appreciated.





Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.