policeman51 1 Report post Posted December 19, 2019 I just did a clean install of Nitro 13.8 and now if I open a PDF or create a new PDF and go to the Stamps drop-down Nitro 13 freezes. I thought that maybe it was my machine so I took a newly imaged machine with no PDF viewers (besides Edge) and did a manual install of Nitro 13.8. Then when I go to the stamps drop-down it still freezes Nitro. I let it sit for around 10 minutes and then the stamps were finally revealed. After that, everytime I open up Nitro and stamps it works correctly. But if I reboot it does the same thing all over again. Has anyone else experienced this? Share this post Link to post Share on other sites
AllainU 0 Report post Posted December 19, 2019 Hello @policeman51, Thank you for reaching out to us through our Community Forums! To further assist you with your concern, Nitro support team decided to created a support ticket on your behalf. For better case handling, kindly wait for an email from a Nitro Support Representative through the support case. Cheers! Share this post Link to post Share on other sites
